REAR NO. 1 SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

2. REMOVE REAR NO. 2 SEAT ASSEMBLY

   
   

   1. Remove the rear No. 2 seat assembly Click here.

3. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

   Click here

4. REMOVE REAR STEP COVER

   Click here

5. REMOVE REAR DOOR SCUFF PLATE

   Click here

6. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

   

   

   Tech Tips

   When removing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.

   
   

   1. Detach the 3 claws and remove the cover.

   2. 

      Remove the bolt and disconnect the rear seat outer belt floor anchor.

   3. 

      for LH side:

      
      

      1. Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor LH.

   4. 

      for RH side:

      
      

      1. Detach the 3 claws and remove the cover.

      2. 

         Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor RH.

   5. w/ Manual Folding-up Function:

      
      

      1. Remove the screw, clip and bolt.

      2. Detach the 19 clips and 2 claws.

         

      3. Disconnect the thermistor connector, power outlet socket connector and rear seat lock control lever cable, and then remove the quarter trim panel.

   6. w/ Automatic Folding-up Function:

      
      

      1. Remove the screw and clip.

      2. Detach the 19 clips and 2 claws.

         

      3. Disconnect the thermistor connector and power outlet socket connector, and then remove the quarter trim panel.

7. REMOVE REAR FRONT QUARTER TRIM GARNISH

   Click here

8. REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY

   

   
   

   1. Remove the nut and seat belt shoulder anchor.

   2. 

      Disconnect the pretensioner connector as shown in the illustration

   3. 

      Remove the 2 bolts and rear No. 1 seat outer belt.

9. REMOVE REAR SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY

   

   
   

   1. Remove the 2 bolts and anchor plate.