FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  3. REMOVE REAR STEP COVER

    Click here

  4. REMOVE REAR DOOR SCUFF PLATE

    Click here

  5. REMOVE CENTER PILLAR GARNISH COVER

    Click here

  6. REMOVE CENTER LOWER PILLAR GARNISH

    Tech Tips


    • When removing the center pillar garnish cover, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position.

    • After moving the front seat, disconnect the cable from the negative (-) battery terminal.


    1. B0018B6

      Remove the bolt and seat belt anchor.

    2. B0018U2

      Detach the 2 claws and 7 clips, and remove the center lower pillar garnish.

  7. REMOVE REAR ASSIST GRIP ASSEMBLY

    Click here

  8. REMOVE CENTER PILLAR GARNISH

    Click here

  9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

    B0018JA

    1. Remove the nut and shoulder anchor.

    2. B00189QE01

      Disconnect the pretensioner connector labeled A as shown in the illustration.

    3. Disconnect the tension reducer connector labeled B.

    4. w/ Pre-Crash Safety System:

      Disconnect the pre-crash safety system connector labeled C.

    5. B0018GX

      Remove the bolt and seat belt.

  10. REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY

    B001AFT

    1. Remove the 2 bolts and anchor plate.