REAR NO. 2 SEAT ASSEMBLY(w/ Automatic Folding-up Function) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL FOLD SEAT SWITCH ASSEMBLY

    B0018II

    1. Attach the claw to install the light.

    2. Connect the connector.

    3. B001AUU

      Attach the 6 clips to install the fold seat switch.

  2. INSTALL REAR SEAT LOCK STRIKER SUB-ASSEMBLY


    1. B001AV1

      Install the 4 seat lock strikers with the 8 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Return the floor carpet to its original position.

  3. INSTALL NO. 3 SEAT CUSHION COVER


    1. B0018P6

      Attach the 16 claws and 4 clips to install the 4 seat cushion covers.

  4. INSTALL FOLD SEAT LEG LOCK SUB-ASSEMBLY


    1. B001AOX

      Install the fold seat leg lock with the 2 nuts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }
    2. B001A4I

      Attach the 2 cable clamps.

    3. Connect the connector.

  5. INSTALL NO. 1 WOOFER BOX SPEAKER ASSEMBLY (for RH Side, w/ Woofer)

    Click here

  6. INSTALL REAR ROOF NO. 1 AIR DUCT (for LH Side)

    Click here

  7. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  8. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  9. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  10. INSTALL REAR STEP COVER

    Click here

  11. INSTALL REAR NO. 2 SEAT ASSEMBLY

    B0018VUE03

    1. Temporarily install the seat with the 4 bolts.

      Note

      Be careful not to damage the vehicle body.

    2. Tighten the bolts in the order shown in the illustration.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    3. Connect the connector.

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  13. INSTALL REAR NO. 2 SEAT HINGE COVER LH

    B001A7I

    1. Attach the 3 claws and 2 clips to install the cover.

  14. INSTALL REAR SEAT CUSHION HINGE COVER LH


    1. B001A2T

      Attach the 3 claws to install the cover.

    2. Return the seat to the upright position.

  15. INSTALL REAR NO. 2 SEAT HEADREST ASSEMBLY LH