REAR NO. 2 SEAT ASSEMBLY(w/ Automatic Folding-up Function) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE REAR NO. 2 SEAT HEADREST ASSEMBLY LH

  2. REMOVE REAR SEAT CUSHION HINGE COVER LH

    B001B0E

    1. Apply protective tape to the rear seatback lock striker as shown in the illustration to prevent the seat from locking.

    2. Operate the power seat switch and move the seat to the storage position.

      Tech Tips

      Make sure that the lock and striker are not engaged.

    3. B001A2T

      Using a screwdriver, detach the 3 claws and remove the cover.

      Tech Tips

      Tape the screwdriver tip before use.

  3. REMOVE REAR NO. 2 SEAT HINGE COVER LH

    B001A7I

    1. Detach the 3 claws and 2 clips, and then remove the cover.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE REAR NO. 2 SEAT ASSEMBLY

    B0018VU

    1. Disconnect the connector.

    2. Remove the 4 bolts and seat assembly.

      Note

      Be careful not to damage the vehicle body.

  6. REMOVE REAR STEP COVER

    Click here

  7. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  8. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  9. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  10. REMOVE REAR ROOF NO. 1 AIR DUCT (for LH Side)

    Click here

  11. REMOVE NO. 1 WOOFER BOX SPEAKER ASSEMBLY (for RH Side, w/ Woofer)

    Click here

  12. REMOVE FOLD SEAT LEG LOCK SUB-ASSEMBLY


    1. B001A4I

      Disconnect the connector.

    2. Detach the 2 cable clamps.

    3. B001AOX

      Remove the 2 nuts and fold seat leg lock.

  13. REMOVE NO. 3 SEAT CUSHION COVER


    1. B0018P6

      Detach the 4 clips and 16 claws, and remove the 4 seat cushion covers.

  14. REMOVE REAR SEAT LOCK STRIKER SUB-ASSEMBLY


    1. Fold back the floor carpet.

    2. B001AV1

      Remove the 8 bolts and 4 seat lock strikers.

  15. REMOVE FOLD SEAT SWITCH ASSEMBLY

    B001AUU

    1. Detach the 6 clips.

    2. Disconnect the connector and then remove the fold seat switch.

    3. B0018II

      Detach the claw and remove the light.