REAR FLOOR AIRBAG SENSOR INSTALLATION

PROCEDURE


  1. INSTALL REAR FLOOR AIRBAG SENSOR


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B0019B7

      Install the rear floor airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the rear floor airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the rear floor airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that there is no looseness in the installation parts of the rear floor airbag sensor.

    5. Connect the connector.

    6. B0019V3

      Attach the clip and claw to install the cover.

    7. Return the floor carpet to its original position.

  2. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

  3. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  4. INSTALL REAR STEP COVER

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

  7. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.