REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR NO. 2 SEAT ASSEMBLY LH


    1. Remove the rear No. 2 seat assembly Click here.

  5. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  6. REMOVE REAR STEP COVER

    Click here

  7. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  9. REMOVE REAR AIRBAG SENSOR


    1. B0019R7

      Remove the bolt and rear airbag sensor.

    2. Disconnect the connector.