SIDE AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL SIDE AIRBAG SENSOR


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. B001A3D

      Install the side airbag sensor with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

      • When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    4. Check that there is no looseness in the installation parts of the side airbag sensor.

    5. Connect the connector.

  2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  4. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  5. INSTALL FRONT ARMREST UPPER BASE PANEL LH (for Driver Side)

    Click here

  6. INSTALL FRONT ARMREST UPPER BASE PANEL RH (for Front Passenger Side)

    Click here

  7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

  11. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.