SIDE AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

    Click here

  5. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  6. REMOVE FRONT ARMREST UPPER BASE PANEL LH (for Driver Side)

    Click here

  7. REMOVE FRONT ARMREST UPPER BASE PANEL RH (for Front Passenger Side)

    Click here

  8. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  10. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  11. REMOVE SIDE AIRBAG SENSOR


    1. B001A3D

      Disconnect the connector.

    2. Remove the bolt and side airbag sensor.