SPIRAL CABLE REMOVAL

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  5. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  6. REMOVE LOWER STEERING COLUMN COVER

    Click here

  7. REMOVE UPPER STEERING COLUMN COVER

    Click here

  8. REMOVE SPIRAL CABLE SUB-ASSEMBLY


    1. Disconnect each connector.

    2. B001APRE01
      Text in Illustration
      *a Lock Slider

      Slide the lock slider to release the lock, and then disconnect the airbag connector.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    3. B00189G

      Detach the 3 claws and remove the spiral cable sub-assembly.

  9. REMOVE SPIRAL CABLE

    Note


    • Remove the spiral cable from the steering sensor only when replacing it.

    • Removing the steering sensor from the spiral cable sub-assembly without using a lock pin may result in a misaligned center position of the steering sensor. Therefore, make sure to use the lock pin provided with a new spiral cable when removing the steering sensor from the spiral cable sub-assembly.


    1. Install the lock pin to the steering sensor.

      Note


      • Use the lock pin provided with a new spiral cable.

      • Do not remove the lock pin before the spiral cable is installed to the steering sensor.

      B0019FS
    2. B00192S

      Detach the 6 claws and remove the spiral cable from the steering sensor.