AIRBAG SYSTEM, Diagnostic DTC:B1000/31

DTC Code DTC Name
B1000/31 Center Airbag Sensor Assembly Malfunction

DESCRIPTION

The center airbag sensor consists of the airbag sensor, the safing sensor, the drive circuit, the diagnosis circuit, the ignition control, etc.

If the center airbag sensor receives signals from the airbag sensor, it determines whether the SRS should be activated.

DTC B1000/31 is output when a malfunction is detected in the center airbag sensor.

DTC Code DTC Detection Condition Trouble Area
B1000/31 A center airbag sensor malfunction. Center airbag sensor assembly

Tech Tips

When a trouble code is output simultaneously with B1000/31, repair the malfunction indicated by the other code first.

CAUTION / NOTICE / HINT

Note


  • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  • When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected Click here.

  • After replacing the center airbag sensor assembly, refer to initialization Click here.

PROCEDURE


  1. CHECK CENTER AIRBAG SENSOR


    1. Turn the engine switch off.

    2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.

    3. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.

    4. Turn the engine switch on (IG), and wait for at least 60 seconds.

    5. Clear the DTCs Click here.

    6. Turn the engine switch off.

    7. Turn the engine switch on (IG), and wait for at least 60 seconds.

    8. Check for DTCs Click here.

      OK
      DTC B1000 is not output.

    OK

    USE SIMULATION METHOD TO CHECK Click here

    NG

    REPLACE CENTER AIRBAG SENSOR ASSEMBLY Click here