TRIP SWITCH INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSPECT LIGHT CONTROL RHEOSTAT (TRIP SWITCH)


    1. A01WRR8E01
      Text in Illustration
      *a ODO TRIP Switch
      *b

      Component without harness connected

      (Light Control Rheostat (Trip Switch))

      Check the resistance.

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      4 (A/B) - 1 (E) ODO TRIP switch on (Pushed) Below 1 Ω
      ODO TRIP switch off (Not pushed) 10 kΩ or higher

      If the result is not as specified, replace the light control rheostat (trip switch).

    2. A01WQQEE01
      Text in Illustration
      *a

      Component without harness connected

      (Light Control Rheostat (Trip Switch))

      Check the illumination.

      Apply battery voltage to the connector and check the illumination condition.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 2 (ILL+)

      Battery negative (-) → Terminal 3 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the light control rheostat (trip switch).