ENGINE HOOD COURTESY SWITCH INSPECTION

PROCEDURE


  1. INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH) (for LHD)


    1. Measure the resistance according to the value(s) in the table below.

      A01WWYBE01
      *1 Component without harness connected: (Hood Lock Assembly)
      *2 Unlock Position
      *3 Lock Position
      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Unlock 10 kΩ or higher
      1 - 2 Lock Below 1 Ω

      If the result is not as specified, replace the hood lock assembly.

  2. REMOVE HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH) (for RHD)


    1. Measure the resistance according to the value(s) in the table below.

      A01WSIRE01
      *1 Component without harness connected: (Hood Lock Assembly)
      *2 Unlock Position
      *3 Lock Position
      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Unlock 10 kΩ or higher
      1 - 2 Lock Below 1 Ω

      If the result is not as specified, replace the hood lock assembly.