ENTRY LOCK AND UNLOCK SWITCH(for Rear) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY LH


    1. B001AUW

      Install the rear door outside handle assembly LH.

      Note

      If the bellcrank lever is not pulled and held when installing the rear door outside handle assembly LH, the bellcrank lever will interfere with the rear door outside handle assembly LH and the release plate may be damaged.

    2. Attach the 2 claws and connect the holder.

    3. Attach the 3 claws to install the connector and connector cover.

  2. INSTALL REAR DOOR OUTSIDE HANDLE COVER LH

    Click here

  3. INSTALL REAR DOOR LOCK ASSEMBLY LH

    Click here

  4. INSTALL REAR DOOR SERVICE HOLE COVER LH

    Click here

  5. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  6. INSTALL ASSIST GRIP COVER LH

    Click here

  7. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  8. INSTALL REAR DOOR UPPER ARMREST BASE PANEL LH

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here