ENTRY LOCK AND UNLOCK SWITCH(for Rear) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR DOOR UPPER ARMREST BASE PANEL LH

    Click here

  4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  5. REMOVE ASSIST GRIP COVER LH

    Click here

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. REMOVE REAR DOOR SERVICE HOLE COVER LH

    Click here

  8. REMOVE REAR DOOR LOCK ASSEMBLY LH

    Click here

  9. REMOVE REAR DOOR OUTSIDE HANDLE COVER LH

    Click here

  10. REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH


    1. B001A6D

      Using a thin-bladed screwdriver, detach the 2 claws.

      Tech Tips

      Tape the thin-bladed screwdriver tip before use.

      Text in Illustration
      B0019VB Protective Tape
    2. B00185A

      Using a thin-bladed screwdriver, detach the claw and disconnect the connector.

      Tech Tips

      Tape the thin-bladed screwdriver tip before use.

      Text in Illustration
      B0019VB Protective Tape
    3. B0019QR

      Detach the 2 claw and disconnect the holder.

    4. B0018WK

      Remove the rear door outside handle assembly LH by sliding and pulling it in the direction indicated by the arrow in the illustration.