| DTC Code | DTC Name |
|---|---|
| B279C | Theft Deterrent System Presence Detection |
DESCRIPTION
If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B279C | An ECM that is incompatible with the engine immobiliser system is installed (1-trip detection logic*). | ECM |
*: Only detected while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC Code | Data List and Active Test |
|---|---|
| B279C | - |
CAUTION / NOTICE / HINT
Note
When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
Before replacing the ECM refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."
PROCEDURE
REPLACE ECM
Replace the ECM with a new one.
for 3UR-FE: Click here
for 1VD-FTV: Click here
| NEXT |
|
END (ECM WAS DEFECTIVE) |