NETWORK GATEWAY ECU(for RHD) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL NETWORK GATEWAY ECU


    1. Install the network gateway ECU with the nut.

    2. Connect the connector.

  2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  3. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  4. INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH

    Click here

  5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  6. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

  7. INSTALL NO. 1 SWITCH HOLE BASE

    Click here

  8. INSTALL INSTRUMENT SIDE PANEL RH

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

  11. CHECK SRS WARNING LIGHT

    Click here