CAUTION / NOTICE / HINT
Tech Tips
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
REMOVE UPPER RADIATOR SUPPORT SEAL
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH
REMOVE REAR DOOR TRIM COVER
REMOVE COURTESY LIGHT ASSEMBLY
REMOVE DOOR ASSIST GRIP COVER LH
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
REMOVE REAR DOOR SERVICE HOLE COVER LH
REMOVE REAR DOOR GLASS RUN LH
REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
REMOVE REAR SPEAKER SET
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
REMOVE REAR DOOR LOCK ASSEMBLY LH
Using a T30 "TORX" socket, remove the 3 screws and rear door lock assembly LH as shown in the illustration..
Note
Be careful when removing the screws as the door lock may fall and become damaged.
Reusing a rear door lock assembly LH:
Remove the door lock wiring harness seal from the rear door lock assembly LH.
REMOVE REAR DOOR LOCK COVER SUB-ASSEMBLY LH
Using a screwdriver, detach the 2 claws.
Tech Tips
Tape the screwdriver tip before use.
|
Protective Tape |
Detach the 2 guides and remove the rear door lock cover sub-assembly LH.
REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
Detach the clamp and remove the rear door inside locking cable assembly LH.
REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
Detach the clamp and remove the rear door lock remote control cable assembly LH.