CAN COMMUNICATION SYSTEM(for LHD) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Central Gateway / Data List.

    5. According to the display on the GTS, read the Data List.

      Central Gateway
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      IG2 SW Engine switch signal / OFF or ON

      OFF: Engine switch off

      ON: Engine switch on (IG)

      		 "OFF" is also displayed for this item when the engine switch is on (ACC)
      IG1 SW Engine switch signal / OFF or ON

      OFF: Engine switch off

      ON: Engine switch on (IG)

      		 "OFF" is also displayed for this item when the engine switch is on (ACC)
      ACC SW Engine switch signal / OFF or ON

      OFF: Engine switch off

      ON: Engine switch on (ACC)

      		 "ON" is also displayed for this item when the engine switch is on (IG)
      +B Voltage Battery voltage / Over 8 V or Under 8 V

      Over 8 V: Battery voltage 8 V or higher

      Under 8 V: Battery voltage below 8 V

      		 -
      Number of DTC The number of the DTC currently stored / Min.: 0, Max.: 255 0 -