LIN COMMUNICATION SYSTEM DATA LIST / ACTIVE TEST


  1. READ DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Main Body / Data List.

    5. According to the display on the intelligent tester, read the Data List.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Communication D-Door Motor Connection status between power window regulator motor (for driver side) and main body ECU (multiplex network body ECU) / OK or STOP

      OK: Connection

      STOP: No connection

      		 When there is a malfunction, a DTC is stored.
      Communication P-Door Motor Connection status between power window regulator motor (for front passenger side) and main body ECU (multiplex network body ECU) / OK or STOP

      OK: Connection

      STOP: No connection

      		 When there is a malfunction, a DTC is stored.
      Communication RR-Door Motor Connection status between power window regulator motor (for rear RH) and main body ECU (multiplex network body ECU) / OK or STOP

      OK: Connection

      STOP: No connection

      		 When there is a malfunction, a DTC is stored.
      Communication RL-Door Motor Connection status between power window regulator motor (for rear LH) and main body ECU (multiplex network body ECU) / OK or STOP

      OK: Connection

      STOP: No connection

      		 When there is a malfunction, a DTC is stored.
      Communication Slide Roof Connection status between sliding roof ECU and main body ECU (multiplex network body ECU) / OK or STOP

      OK: Connection

      STOP: No connection

      		 When there is a malfunction, a DTC is stored.
      Communication Master SW Connection status between power window ECU (master switch) and main body ECU (multiplex network body ECU) / OK or STOP

      OK: Connection

      STOP: No connection

      		 When there is a malfunction, a DTC is stored.
      Number of Trouble Codes Number of trouble codes / Min.: 0, Max.: 255 Number of DTCs will be displayed -