GENERATOR(for 150 A Type) INSTALLATION

PROCEDURE

1. INSTALL GENERATOR ASSEMBLY

   
   

   1. Install the stud bolt to the cylinder block.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

   2. Install the generator assembly with the 3 bolts and nut.

      Torque:

      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

   3. Install the wire harness clamp bracket to the generator assembly with the bolt.

      Torque:

      31 N*m  { 316 kgf*cm, 23 ft.*lbf }

   4. Attach the clamp and connect the generator wire.

   5. Connect the generator wire to terminal B with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   6. Install the terminal cap.

   7. Connect the generator connector.

2. CONNECT OIL COOLER TUBE

   Click here

3. CONNECT VANE PUMP ASSEMBLY

   Click here

4. INSTALL AIR CLEANER ASSEMBLY

   Click here

5. INSTALL AIR CLEANER HOSE ASSEMBLY

   Click here

6. INSTALL FAN AND GENERATOR V BELT

   Click here

7. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

   Click here

8. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

   Click here

9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

   Click here

10. INSTALL FRONT FENDER APRON TRIM PACKING A

    Click here

11. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

12. INSTALL UPPER RADIATOR SUPPORT SEAL

    Click here

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.