BLIND SPOT MONITOR SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Avoid any impact to the blind spot monitor sensor.

  • Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

PROCEDURE


  1. INSTALL BLIND SPOT MONITOR BRACKET LH


    1. Install the blind spot monitor bracket LH with the 3 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  2. INSTALL BLIND SPOT MONITOR BRACKET RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. INSTALL BLIND SPOT MONITOR SENSOR LH


    1. Install the blind spot monitor sensor LH with the 3 nuts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    2. Connect the connector.

  4. INSTALL BLIND SPOT MONITOR SENSOR RH


    1. Use the same procedure described for the LH side.

  5. PERFORM BLIND SPOT MONITOR INSTALLATION CONDITION INSPECTION

    Click here

  6. INSTALL REAR BUMPER COVER


    1. for Standard:

      Click here

    2. w/ Towing Hitch:

      Click here

    3. w/ Pintle Hook:

      Click here

  7. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION

    Click here

  8. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION

    Click here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here