ULTRASONIC SENSOR(for Rear) INSTALLATION

PROCEDURE


  1. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Perform this step only when necessary.

    • If a No. 2 ultrasonic sensor retainer has been removed, replace it with a new one. Install the No. 2 ultrasonic sensor with a new No. 2 ultrasonic sensor retainer as a set to the rear bumper cover.

    • The illustration shows the No. 2 ultrasonic sensor retainer for the LH corner and back sensor retainer LH. The horizontal orientation of the No. 2 ultrasonic sensor retainer for the RH and back sensor retainer RH are opposite that of the image shown in the illustration.


    1. Clean the rear bumper cover surface.


      1. Remove the double-sided tape from the rear bumper cover.

      2. Wipe off any tape adhesive residue with cleaner.

    2. B001APEE02
      Text in Illustration
      *a 18.5 mm (0.73 in.)

      Cover the sensor installation hole with a 18.5 mm (0.73 in.) square piece of tape.

    3. B0019YVE02
      Text in Illustration
      *a Primer

      Using a brush or felt, apply primer or equivalent to the No. 2 ultrasonic sensor retainer installation area.

      Note


      • Use a clean brush or felt.

      • Do not touch the rear bumper cover until the primer has dried.

    4. Peel off the release paper from the No. 2 ultrasonic sensor retainer.

    5. B0019COE04
      Text in Illustration
      *a Protrusion of the mark
      *b Double-sided Tape

      Align the No. 2 ultrasonic sensor retainer with the mark on the rear bumper cover and install it as shown in the illustration.

      Note

      The double-sided tape of a No. 2 ultrasonic sensor retainer will deteriorate if it is detached. Make sure to replace the No. 2 ultrasonic sensor retainer with a new one when reattachment is necessary.

      Tech Tips


      • Align the connector with the protrusion of the mark and connect it.

      • Press the No. 2 ultrasonic sensor retainer with a force of 30 N (3.0 kgf) for 3 seconds and install the No. 2 ultrasonic sensor retainer firmly so that there is no clearance between the No. 2 ultrasonic sensor retainer and rear bumper cover.

  2. INSTALL NO. 2 ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure to install the No. 2 ultrasonic sensor on the other side.


    1. Attach the 2 claws to install the No. 2 ultrasonic sensor.

    2. Connect the connector.

  3. INSTALL REAR BUMPER COVER


    1. for Standard:

      Click here

    2. w/ Towing Hitch:

      Click here

    3. w/ Pintle Hook:

      Click here