TELEMATICS TRANSCEIVER INSTALLATION

PROCEDURE

1. INSTALL NO. 1 TELEPHONE BRACKET

   Install the No. 1 telephone bracket Click here.

2. INSTALL NO. 2 TELEPHONE BRACKET

   
   

   1. Install the telephone bracket RH to the telematics transceiver with the 2 screws.

      Torque:

      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

   2. Install the telephone bracket LH to the telematics transceiver with the 2 screws.

      Torque:

      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

3. INSTALL TELEMATICS TRANSCEIVER

   
   

   1. Install the telematics transceiver with bracket with the 3 screws.

      Torque:

      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

   2. Connect the connectors.

4. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY

   Click here

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

6. INSTALL UPPER RADIATOR SUPPORT SEAL

   Click here

7. CHECK SRS WARNING LIGHT

   
   

   1. Check the SRS warning light Click here.

8. PERFORM REGISTRATION

   
   

   1. Perform registration Click here.

      Note

      When replacing the telematics transceiver, perform registration.