TELEMATICS SYSTEM(w/ Telematics Transceiver for G-BOOK) Received Voice Signal Circuit

WIRING DIAGRAM

A01WTWQE06
*a Multi-media Module Receiver Assembly
*b Telematics Transceiver

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for G-BOOK Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - TELEMATICS TRANSCEIVER)


    1. Disconnect the F103 multi-media module receiver assembly connector.

    2. Disconnect the P7 telematics transceiver connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F103-7 (VOR+) - P7-3 (VOT+) Always Below 1 Ω
      F103-6 (VOR-) - P7-5 (VOT-) Always Below 1 Ω
      F103-7 (VOR+) - Body ground Always 10 kΩ or higher
      F103-6 (VOR-) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT TELEMATICS TRANSCEIVER


    1. Remove the telematics transceiver with the connectors still connected.

    2. A01WQ2UE02
      Text in Illustration
      *a

      Component with harness connected

      (Telematics Transceiver)

      Check for pulses according to the value(s) in the table below.

      Standard
      Tester Connection Condition Specified Condition
      P7-3 (VOT+) - Body ground Receiving a call while using the operator service A waveform synchronized with the received voice is output.
      P7-5 (VOT-) - Body ground Receiving a call while using the operator service A waveform synchronized with the received voice is output.

    OK

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here

    NG

    REPLACE TELEMATICS TRANSCEIVER Click here