| DTC Code | DTC Name |
|---|---|
| B1573 | Short in Telephone Antenna Circuit |
| B15CB | Telephone Antenna Disconnected |
DESCRIPTION
These DTCs are stored when a malfunction occurs in the telephone antenna.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1573 | Short in Telephone Antenna Circuit | Telephone antenna assembly impedance (Ω) is lower than the malfunction threshold for 20 seconds when the engine switch is on (IG). (Short circuit) |
|
| B15CB | Telephone Antenna Disconnected | Telephone antenna assembly impedance (Ω) is higher than the malfunction threshold for 20 seconds when the engine switch is on (IG). (Open circuit) |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Note
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.
PROCEDURE
CHECK FOR DTC
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and wait for 20 seconds.
Turn the GTS on.
Check for DTCs and check that no DTCs are output.
| OK |
|---|
| No DTCs are output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
USE SIMULATION METHOD TO CHECK Click here |
| NG |
|
INSPECT TELEPHONE ANTENNA ASSEMBLY
Remove the telephone antenna assembly.
| *a | Component without harness connected (Telephone Antenna Assembly) |
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE TELEPHONE ANTENNA ASSEMBLY Click here |
| OK |
|
INSPECT NO. 4 ANTENNA CORD SUB-ASSEMBLY
| *a | Front view of wire harness connector (to Telephone Antenna Assembly) |
| *b | Front view of wire harness connector (to Wire Harness) |
Disconnect the antenna connector from the telephone antenna assembly.
Disconnect the antenna connector from the wire harness.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE NO. 4 ANTENNA CORD SUB-ASSEMBLY Click here |
| OK |
|
CHECK HARNESS AND CONNECTOR (NO. 4 ANTENNA CORD SUB-ASSEMBLY - TELEMATICS TRANSCEIVER)
| *a | Front view of wire harness connector (to No. 4 Antenna Cord Sub-assembly) |
| *b | Front view of wire harness connector (to Telematics Transceiver) |
Disconnect the antenna connector from the No. 4 antenna cord sub-assembly.
Disconnect the antenna connector from the telematics transceiver.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
REPLACE TELEMATICS TRANSCEIVER
Replace the telematics transceiver with a new one.
| Result | ||
|---|---|---|
|
| NEXT |
|
PERFORM REGISTRATION Click here |