| DTC Code | DTC Name |
|---|---|
| B15CC | Backup Battery Failure |
DESCRIPTION
This DTC is stored when the telematics transceiver receives a result "Defect", "High Temperature" or "Low Voltage" or cannot receive any signals during the mayday battery self check.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15CC | Mayday battery malfunction |
|
WIRING DIAGRAM
| *a | Telematics Transceiver |
| *b | Mayday Battery |
CAUTION / NOTICE / HINT
Note
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for G-BOOK Click here.
PROCEDURE
CHECK DTC OUTPUT
Clear the DTCs Click here.
Recheck for DTCs and check if the same DTC is output again Click here.
| OK |
|---|
| B15CC is not output. |
| OK |
|
USE SIMULATION METHOD TO CHECK Click here |
| NG |
|
CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - MAYDAY BATTERY)
Disconnect the P2 telematics transceiver connector.
Disconnect the j1 mayday battery connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
CHECK MAYDAY BATTERY
Replace the mayday battery with a normal one and check if the same problem occurs again Click here.
Clear the DTCs Click here.
Recheck for DTCs and check if the same DTC is output again Click here.
| OK |
|---|
| B15CC is not output. |
| OK |
|
END (MAYDAY BATTERY IS DEFECTIVE) |
| NG |
|
REPLACE TELEMATICS TRANSCEIVER Click here |