REAR SEAT ENTERTAINMENT SYSTEM Display Mode Signal Circuit between Multi-display Controller and Television Display Assembly

DESCRIPTION

This is the display mode signal circuit between the multi-display controller sub-assembly and television display assembly RH.

WIRING DIAGRAM

A01WTSSE31
*a Television Display Assembly RH
*b Multi-display Controller Sub-assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY - TELEVISION DISPLAY ASSEMBLY RH)


    1. Disconnect the L80 multi-display controller sub-assembly connector.

    2. Disconnect the c66 television display assembly RH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L80-9 (MDO) - c66-1 (MDO) Always Below 1 Ω
      L80-9 (MDO) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR