STEERING COLUMN ASSEMBLY ON-VEHICLE INSPECTION

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

  3. REMOVE LOWER STEERING COLUMN COVER

    Click here

  4. REMOVE UPPER STEERING COLUMN COVER

    Click here

  5. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  6. INSPECT TELESCOPIC MOTOR


    1. Inspect the tilt motor:


      1. Disconnect the tilt motor connector.

      2. B0018NUE01

        Apply 12 V battery voltage to the tilt motor connector. Then check the steering wheel tilt operation.

        OK
        Measurement Condition Specified Condition

        12 V battery positive (+) lead → Terminal 1 (TIM+)

        12 V battery negative (-) lead → Terminal 2 (TIM-)

        		 The steering wheel tilts up.

        12 V battery negative (-) lead → Terminal 1 (TIM+)

        12 V battery positive (+) lead → Terminal 2 (TIM-)

        		 The steering wheel tilts down.

        If the result is not as specified, replace the steering column assembly.

    2. Inspect the telescopic motor:


      1. Disconnect the telescopic motor connector.

      2. B0018N7E01

        Apply 12 V battery voltage to the telescopic motor connector. Then check the steering column telescopic operation.

        OK
        Measurement Condition Specified Condition

        12 V battery positive (+) lead → Terminal 2 (TEM+)

        12 V battery negative (-) lead → Terminal 1 (TEM-)

        		 The steering column contracts.

        12 V battery positive (+) lead → Terminal 1 (TEM-)

        12 V battery negative (-) lead → Terminal 2 (TEM+)

        		 The steering column extends.

        If the result is not as specified, replace the steering column assembly.

  7. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  8. INSTALL UPPER STEERING COLUMN COVER

    Click here

  9. INSTALL LOWER STEERING COLUMN COVER

    Click here

  10. CHECK SRS WARNING LIGHT

    Click here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here