TILT AND TELESCOPIC MANUAL SWITCH REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disable the AUTO TILT AWAY function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the AUTO TILT AWAY function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER STEERING COLUMN COVER


    1. B001A9T

      Remove the 2 screws.

      Tech Tips

      Turn the steering wheel to the right and left as necessary to remove the 2 screws.

    2. B00192RE02
      *1 Push Area

      Remove the screw and while pressing the push area shown in the illustration to detach the 2 claws, slightly lower steering column cover.

  4. REMOVE TILT AND TELESCOPIC MANUAL SWITCH


    1. B0019OX

      Disconnect the switch connector.

    2. Detach the claw and pull out the switch.

      Note

      Pushing on the claw too hard will break the claw.