STEERING WHEEL INSTALLATION

PROCEDURE


  1. ADJUST SPIRAL CABLE SUB-ASSEMBLY

    Click here

  2. INSTALL STEERING WHEEL ASSEMBLY


    1. B0019NIE01
      *1 Matchmark

      Align the matchmarks on the steering wheel and main shaft.

    2. Install the steering wheel set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

  3. INSTALL STEERING PAD

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note


    • Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. CHECK SRS WARNING LIGHT

    Click here

  6. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION

    Click here