VANE PUMP(for 1VD-FTV) REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

3. REMOVE UPPER RADIATOR SUPPORT SEAL

   Click here

4. REMOVE FRONT FENDER APRON TRIM PACKING A

   Click here

5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

   Click here

6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   Click here

7. REMOVE NO. 1 AIR CLEANER HOSE

   Click here

8. REMOVE INTAKE AIR CONNECTOR

   Click here

9. REMOVE RADIATOR RESERVE TANK ASSEMBLY

   Click here

10. REMOVE V-RIBBED BELT (w/ Viscous Heater)

    Click here

11. REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)

    Click here

12. REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)

    Click here

13. REMOVE V-RIBBED BELT

    Click here

14. DRAIN POWER STEERING FLUID

15. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

    
    

    1. 

       Slide the clip and disconnect the No. 1 oil reservoir to pump hose from the vane pump.

16. REMOVE PRESSURE FEED TUBE ASSEMBLY

    
    

    1. 

       Disconnect the 2 connectors.

    2. 

       Remove the union bolt, union and disconnect the pressure feed tube.

    3. Remove the gasket.

17. REMOVE VANE PUMP ASSEMBLY

    
    

    1. 

       Remove the 2 nuts and vane pump.

    2. Remove the O-ring from the vane pump.