VANE PUMP(for 3UR-FE) INSTALLATION

PROCEDURE


  1. INSTALL VANE PUMP ASSEMBLY


    1. B0018I5

      Install the vane pump with the 2 bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

  2. CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


    1. Coat a new O-ring with power steering fluid and install the O-ring to the No. 1 oil reservoir to pump hose.

    2. B001A2A

      Install the No. 1 oil reservoir to pump hose with the bolt.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    3. Connect the No. 1 oil reservoir to pump hose to the oil reservoir with the clip.

  3. CONNECT PRESSURE FEED TUBE ASSEMBLY


    1. Install a new gasket to the pressure feed tube.

    2. B001854

      Connect the pressure feed tube with the union bolt.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }
    3. B0019G9

      Connect the 2 connectors and attach the 2 wire harness clamps.

  4. INSTALL FAN AND GENERATOR V BELT

    Click here

  5. INSTALL AIR CLEANER ASSEMBLY

    Click here

  6. INSTALL AIR CLEANER HOSE ASSEMBLY

    Click here

  7. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  8. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  9. INSTALL FRONT FENDER APRON TRIM PACKING A

    Click here

  10. INSTALL FRONT WHEEL RH

  11. ADD POWER STEERING FLUID

  12. BLEED POWER STEERING FLUID

    Click here

  13. INSPECT FOR POWER STEERING FLUID LEAK

  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.