VANE PUMP(for 3UR-FE) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WHEEL RH

  4. REMOVE FRONT FENDER APRON TRIM PACKING A

    Click here

  5. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  6. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  7. REMOVE AIR CLEANER HOSE ASSEMBLY

    Click here

  8. REMOVE AIR CLEANER ASSEMBLY

    Click here

  9. REMOVE FAN AND GENERATOR V BELT

    Click here

  10. DRAIN POWER STEERING FLUID

  11. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


    1. B0019G9

      Detach the 2 wire harness clamps and disconnect the 2 connectors.

    2. B001854

      Remove the union bolt and disconnect the pressure feed tube.

    3. Remove the gasket.

  12. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


    1. B001A2A

      Slide the clip and disconnect the No. 1 oil reservoir to pump hose from the oil reservoir.

    2. Remove the bolt and No. 1 oil reservoir to pump hose.

  13. REMOVE VANE PUMP ASSEMBLY


    1. B0018I5

      Remove the 2 bolts and vane pump.