STEERING CONTROL ECU(for LHD) INSTALLATION

PROCEDURE

1. INSTALL STEERING CONTROL ECU

   
   

   1. Attach the 2 claws and install the steering control ECU to the junction block with the 2 bolts.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   2. Connect the connectors.

   3. Install the junction block with the bolt and 2 nuts.

      Torque:

      7.6 N*m  { 77 kgf*cm, 67 in.*lbf }

2. INSTALL INSTRUMENT PANEL BOX ASSEMBLY

   Click here

3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. CHECK SRS WARNING LIGHT

   Click here

6. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION

   Click here