FRONT BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL FRONT FLEXIBLE HOSE


    1. A01WQP7E03
      *1 Fulcrum Length
      *2 Union Nut Wrench

      Install a new clip to the flexible hose.

    2. Using a union nut wrench, connect the brake tube to the flexible hose while holding the flexible hose with a wrench.

      Torque:
      without union nut wrench
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }
      with union nut wrench
      14 N*m  { 145 kgf*cm, 10 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      • The torque value for use with a union nut wrench is effective when the union nut wrench is parallel to the torque wrench.

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

    3. Install the bolt.

      Torque:
      31 N*m  { 316 kgf*cm, 23 ft.*lbf }
    4. A01WVPQ

      Install a new gasket and connect the flexible hose with the new union bolt.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

  2. BLEED BRAKE LINE

    Click here

  3. INSTALL FRONT WHEEL

    Torque:
    131 N*m  { 1336 kgf*cm, 97 ft.*lbf }