REAR SPEED SENSOR INSTALLATION

PROCEDURE


  1. INSTALL REAR SPEED SENSOR LH


    1. B00184U

      Install the speed sensor with the nut.

      Torque:
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

      Note


      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

      • Make sure there is no foreign matter attached to the speed sensor rotor.

  2. INSTALL REAR SPEED SENSOR RH


    1. B0018V9

      Install the speed sensor with the nut.

      Torque:
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

      Note


      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

      • Make sure there is no foreign matter attached to the speed sensor rotor.

  3. INSTALL SKID CONTROL SENSOR WIRE


    1. B0018QW

      Install the sensor clamp with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

      Note

      Make sure the clamp rotation stopper touches the installation position.

    2. Connect the connector.

      Note


      • Securely insert the connector.

      • When connecting the connector, do not twist the wire harness.

    3. B0019HV

      Install the sensor clamp with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

      Note

      Make sure the clamp rotation stopper touches the installation position.

    4. B00192Y

      Connect the speed sensor RH connector.

      Note


      • Securely connect the connector.

      • When connecting the connector, do not twist the wire harness.

    5. Attach the 3 clamps.

      B0019KU

      Note


      • When attaching the clamps, do not twist the wire harness.

      • When attaching the clamps, securely insert them as shown in the illustration.

    6. Attach the 5 clamps.

      B0018XR

      Note


      • When attaching the clamps, do not twist the wire harness.

      • When attaching the clamps, securely insert them as shown in the illustration.

    7. Attach the 2 clamps and install the sensor clamp with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }
      B001ANW
    8. B00193E

      Connect the speed sensor LH connector.

      Note


      • Securely connect the connector.

      • When connecting the connector, do not twist the wire harness.

  4. INSTALL REAR WHEEL

    Torque:
    131 N*m  { 1336 kgf*cm, 97 ft.*lbf }

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. CHECK SPEED SENSOR SIGNAL

    Click here