VEHICLE STABILITY CONTROL SYSTEM TS and CG Terminal Circuit

DESCRIPTION

The signal check circuit detects trouble in the sensor or switch signal which cannot be detected by the DTC check.

Connecting terminals TS and CG of the DLC3 starts the check.

WIRING DIAGRAM

A01WVK0E02
*a Skid Control ECU (Brake Actuator Assembly)

CAUTION / NOTICE / HINT

Note

After replacing the master cylinder solenoid, perform zero point calibration and store the system information Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3 (TS))


    1. Turn the engine switch off.

    2. Disconnect the A24 skid control ECU (master cylinder solenoid) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A24-24 (TS) - E22-12 (TS) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. CHECK HARNESS AND CONNECTOR (DLC3 (CG) - BODY GROUND)


    1. A01WTL1E01
      Text in Illustration
      *1 DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E22-4 (CG) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (DLC3 (TS) - BODY GROUND)


    1. A01WWN9E01
      Text in Illustration
      *1 DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E22-12 (TS) - Body ground Always 10 kΩ or higher
      Result
      Result Proceed to
      NG A
      OK (for LHD) B
      OK (for RHD) C

    A

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    B

    REPLACE MASTER CYLINDER SOLENOID Click here

    C

    REPLACE MASTER CYLINDER SOLENOID Click here