VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1436

DTC Code DTC Name
C1436 Yaw Rate Sensor Malfunction

DESCRIPTION

Refer to DTC C1419 and C1435 Click here.

DTC Code DTC Detection Condition Trouble Area
C1436

Either condition is met:


  1. With the vehicle stationary, the yaw rate and acceleration sensor output value is not 0°/s.

  2. An abnormal comparison value.

 Yaw rate sensor (Airbag sensor assembly)

WIRING DIAGRAM

Refer to DTCs C1232, C1243 and C1245 Click here.

CAUTION / NOTICE / HINT

Note

After replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform calibration Click here.

PROCEDURE


  1. CHECK DTC (CAN COMMUNICATION SYSTEM)


    1. for LHD:

      Check for DTCs Click here.

    2. for RHD:

      Check for DTCs Click here.

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output (for LHD) B
      CAN DTC is output (for RHD) C

    B

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    C

    GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here

    A

  2. READ VALUE USING GTS (YAW RATE SENSOR)


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch to ON.

    4. Turn the GTS on.

    5. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Yaw Rate Sensor Yaw rate sensor/ Min.: -128°/s, Max.: 127°/s

      Vehicle stationary: 0°/s

      Right turn: -128 to 0°/s

      Left turn: 0 to 127°/s

      		 -

    6. Check that the yaw rate and acceleration sensor (airbag sensor assembly) output value is displayed on the GTS.

      Result
      Result Proceed to
      NG Yaw rate and acceleration sensor (Airbag sensor assembly) output value is 0°/s when vehicle is stationary, but value fluctuates when turning A
      Yaw rate and acceleration sensor (Airbag sensor assembly) output value is not 0°/s when vehicle is stationary B
      OK C

    B

    REPLACE AIRBAG SENSOR ASSEMBLY Click here

    C

    CHECK FOR INTERMITTENT PROBLEMS Click here

    A

  3. CHECK AIRBAG SENSOR ASSEMBLY INSTALLATION


    1. Turn the engine switch off.

    2. Check that the yaw rate and acceleration sensor (airbag sensor assembly) is installed properly Click here.

      OK
      The sensor is tightened to the specified torque.
      The sensor is not installed at an angle.

    OK

    REPLACE AIRBAG SENSOR ASSEMBLY Click here

    NG

    INSTALL AIRBAG SENSOR ASSEMBLY CORRECTLY Click here