REAR UPPER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH


    1. B001AJH

      Temporarily install the rear upper control arm and 2 washers with the 2 bolts and 2 nuts.

  2. STABILIZE SUSPENSION

    Click here

  3. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH


    1. Tighten the 2 nuts.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

      Note

      Perform this procedure with all 4 wheels on the ground.

  4. INSTALL UPPER ARM BUSH HEAT INSULATOR


    1. B001932

      Install the upper arm bush heat insulator with the bolt.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  5. CONNECT SPEED SENSOR WIRE HARNESS


    1. B001AV4

      Connect the speed sensor wire harness with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

  6. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. PERFORM VEHICLE OFF SET CALIBRATION


    1. Perform the vehicle off set calibration Click here.

  9. ADJUST REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

    Click here

  10. ADJUST HEADLIGHT ASSEMBLY


    1. Adjust the headlight assembly Click here.