REAR UPPER ARM REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

    Click here

  4. DISCONNECT SPEED SENSOR WIRE HARNESS


    1. B001AV4

      Remove the bolt and disconnect the speed sensor wire harness from the upper control arm.

  5. REMOVE UPPER ARM BUSH HEAT INSULATOR


    1. B001932

      Remove the bolt and upper arm bush heat insulator.

  6. SUPPORT REAR AXLE HOUSING ASSEMBLY

    Click here

  7. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH


    1. B001AJH

      Remove the 2 nuts, 2 washers, 2 bolts and upper control arm.