SUSPENSION CONTROL ECU INSTALLATION

PROCEDURE

1. INSTALL SUSPENSION CONTROL ECU

   
   

   1. 

      Attach the wire harness clamp and connect the connector.

   2. Install the ECU with the 2 bolts.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

2. INSTALL REAR SIDE NO. 2 AIR DUCT

   Click here

3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

   Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION

   
   

   1. Perform the vehicle height offset calibration Click here.

6. PERFORM ZERO POINT CALIBRATION OF G SENSOR

   
   

   1. Perform the zero point calibration of the G sensor Click here.

7. ADJUST HEADLIGHT ASSEMBLY

   
   

   1. Adjust the headlight Click here.