SUSPENSION CONTROL ECU REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  4. REMOVE REAR SIDE NO. 2 AIR DUCT

    Click here

  5. REMOVE SUSPENSION CONTROL ECU


    1. B00199N

      Remove the 2 bolts and ECU.

    2. Detach the wire harness clamp and disconnect the connector.