HEIGHT CONTROL SENSOR(for Rear Side) INSTALLATION

PROCEDURE

1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

   
   

   1. 

      Install the sensor with the 2 bolts and nut.

      Torque:

      for bolt

      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

      for nut

      5.6 N*m  { 57 kgf*cm, 50 in.*lbf }

   2. Connect the connector and 2 clamps.

2. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH

   
   

   1. 

      Install the sensor with the 2 bolts and nut.

      Torque:

      for bolt

      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

      for nut

      5.6 N*m  { 57 kgf*cm, 50 in.*lbf }

   2. Connect the connector and 2 clamps.

3. INSTALL REAR WHEEL

   Torque:

   131 N*m  { 1336 kgf*cm, 97 ft.*lbf }

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION

   
   

   1. Perform the vehicle height offset calibration Click here.

6. ADJUST REAR HEIGHT SENSOR LINK SUB-ASSEMBLY

   Click here

7. PERFORM ZERO POINT CALIBRATION OF G SENSOR

   
   

   1. Perform the zero point calibration of the G sensor Click here.

8. ADJUST HEADLIGHT ASSEMBLY

   
   

   1. Adjust the headlight Click here.