REAR AXLE SHAFT INSTALLATION

PROCEDURE


  1. INSTALL REAR AXLE SHAFT OIL SEAL LH


    1. B001AE5E03

      Using SST and a hammer, tap in a new oil seal.

      Note

      Do not allow foreign matter, etc. to contact the axle shaft housing hole.

      SST
      09950-60020   ( 09951-00770 )
      09950-70010   ( 09951-07150 )

  2. INSTALL REAR AXLE SHAFT LH


    1. Install the O-ring to the axle housing.

    2. B0019JF

      Install the rear axle shaft and parking brake plate with the 4 nuts.

      Torque:
      60 N*m  { 612 kgf*cm, 44 ft.*lbf }

  3. CONNECT REAR SPEED SENSOR LH

    Click here

  4. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  5. INSTALL PARKING BRAKE SHOE LEVER SUB-ASSEMBLY LH

    Click here

  6. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY LH

    Click here

  7. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY LH

    Click here

  8. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING LH

    Click here

  9. CHECK PARKING BRAKE INSTALLATION

    Click here

  10. INSTALL REAR DISC LH

    Click here

  11. CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. B001950

      Connect the rear disc brake cylinder and install 2 new bolts.

      Torque:
      154 N*m  { 1570 kgf*cm, 114 ft.*lbf }

      Note


      • Do not twist the flexible hose.

      • Make sure that the bolts are free from damage and foreign matter.

      • Do not overtighten the bolts.

  12. CONNECT REAR BRAKE FLEXIBLE HOSE


    1. Set the flexible hose to the connecting point with the brake tube, and then install a new clip.

    2. B0018EDE04
      *1 Fulcrum Length
      *2 Union Nut Wrench

      Using union nut wrench, connect the flexible hose to the brake tube while holding the flexible hose with a wrench.

      Torque:
      without union nut wrench
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }
      with union nut wrench
      14 N*m  { 145 kgf*cm, 10 ft.*lbf }

      Tech Tips

      Use a torque wrench with a fulcrum length of 30 cm (11.8 in.).

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  14. BLEED BRAKE LINE

    Click here

  15. INSPECT DIFFERENTIAL OIL

    Click here

  16. INSPECT FOR DIFFERENTIAL OIL LEAK

  17. ADJUST PARKING BRAKE SHOE CLEARANCE

    Click here

  18. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.

  19. CHECK SPEED SENSOR SIGNAL


    1. Check the speed sensor signal Click here.

  20. INSTALL REAR WHEEL LH

    Torque:
    131 N*m  { 1336 kgf*cm, 97 ft.*lbf }