STEERING KNUCKLE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL STEERING KNUCKLE OIL SEAL LH


    1. B0018SXE01

      Using SST and a press, press in a new oil seal.

      SST
      09950-60020   ( 09951-01030 )
      09950-70010   ( 09951-07100 )

      Note


      • The oil seal is a non-reusable part.

      • Do not damage the steering knuckle oil seal.

  2. INSTALL STEERING KNUCKLE LH


    1. Install the steering knuckle to the front suspension upper arm with a new nut.

      Torque:
      110 N*m  { 1122 kgf*cm, 81 ft.*lbf }

    2. Install a new clip.

      Tech Tips

      If the holes for the clip are not aligned, tighten the nut up to another 60°.

  3. CONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

    Click here

  4. CONNECT TIE ROD END SUB-ASSEMBLY LH


    1. Connect the tie rod end LH to the steering knuckle with a new nut.

      Torque:
      69 N*m  { 704 kgf*cm, 51 ft.*lbf }

    2. Install a new cotter pin.

      Tech Tips

      If the holes for the cotter pin are not aligned, tighten the nut up to another 60°.

  5. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

    Click here

  6. CONNECT FRONT SPEED SENSOR LH


    1. B001AC4

      Install the speed sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

      • Make sure there is no foreign matter attached to the magnetic rotor.

    2. B0019ZF

      Install the skid control sensor clamp and sensor wire with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

  7. INSTALL FRONT WHEEL

    Torque:
    131 N*m  { 1336 kgf*cm, 97 ft.*lbf }

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. CHECK SPEED SENSOR SIGNAL

    Click here

  10. CHECK SRS WARNING LIGHT

    Click here

  11. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

  12. ADJUST HEADLIGHT ASSEMBLY

    Click here