STEERING KNUCKLE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. DISCONNECT FRONT SPEED SENSOR LH


    1. B0019ZF

      Remove the bolt, skid control sensor clamp and sensor wire.

    2. B001AC4

      Remove the bolt and speed sensor from the knuckle.

    3. Note

      Pull out the sensor while trying as much as possible not to rotate it.

  3. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH


    1. Remove the front axle hub Click here.

  4. DISCONNECT TIE ROD END SUB-ASSEMBLY LH


    1. Remove the cotter pin and nut.

    2. B001AJPE01

      Using SST, disconnect the tie rod end LH from the steering knuckle.

      SST
      09610-20012

      Note


      • Do not damage the front disc brake dust cover.

      • Do not damage the ball joint dust cover.

      • Do not damage the steering knuckle.

  5. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

    Click here

  6. REMOVE STEERING KNUCKLE LH


    1. Support the front suspension lower arm LH with a jack.

    2. Remove the clip and nut.

    3. B001AI2E12

      Using SST, disconnect the upper ball joint from the steering knuckle.

      SST
      09628-62011

      Note

      Do not damage the ball joint dust cover.

    4. Remove the steering knuckle.

  7. REMOVE STEERING KNUCKLE OIL SEAL LH


    1. B0018P0

      Using a screwdriver and hammer, tap out the oil seal.