FRONT AXLE HUB ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  3. REMOVE FRONT DISC

    Click here

  4. REMOVE FRONT AXLE HUB GREASE CAP LH

    Click here

  5. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. A01WWI0

      Using a dial indicator, measure the looseness near the center of the axle hub.

      Maximum looseness
      0.05 mm (0.00197 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the looseness exceeds the maximum, replace the axle hub.

  6. INSPECT FRONT AXLE HUB RUNOUT


    1. A01WRF0

      Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.

      Maximum runout
      0.08 mm (0.00315 in.)

      Note

      Ensure that the dial indicator is set at a right angle to the measurement surface.

      If the runout exceeds the maximum, replace the axle hub.

  7. INSTALL FRONT AXLE HUB GREASE CAP LH

    Click here

  8. INSTALL FRONT DISC

    Click here

  9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  10. INSTALL FRONT WHEEL

    Torque:
    131 N*m  { 1336 kgf*cm, 97 ft.*lbf }