FRONT DRIVE SHAFT ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH


    1. Coat the lip of the differential oil seal with MP grease.

      Tech Tips

      Inspect the oil seal for wear or damage.

    2. Coat the spline of the inboard joint shaft assembly with hypoid gear oil.

    3. B001A4R

      Align the shaft splines and install the drive shaft with a brass bar and hammer.

      Note


      • Set the snap ring with the opening side facing downward.

      • Be careful not to damage the oil seal, boot and dust cover.

      • If the outboard joint shaft is new, remove the anti-rust oil on the screw end with non-residue solvent.

      Tech Tips

      Whether the inboard joint shaft is in contact with the pinion shaft or not can be confirmed from the sound or feeling when driving it.

  2. INSTALL FRONT AXLE ASSEMBLY LH

    Click here

  3. ADD DIFFERENTIAL OIL

    Click here

  4. CHECK SPEED SENSOR SIGNAL

    Click here

  5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

  6. ADJUST HEADLIGHT ASSEMBLY

    Click here

  7. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  8. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  10. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here