4WD CONTROL SWITCH INSPECTION

PROCEDURE


  1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


  2. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (4WD CONTROL SWITCH)


    1. B0019C2E25
      Text in Illustration
      *a

      Component without harness connected

      (Integration Control and Panel Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 (E) - 21 (2ND) H4 Position 10 kΩ or higher
      L4 Position Below 1 Ω

      If the result is not as specified, replace the integration control and panel assembly.

  3. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY