FRONT DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips

The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

PROCEDURE


  1. DRAIN DIFFERENTIAL OIL

    Click here

  2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

    Click here

  3. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL


    1. A01WPU5E05

      Using SST, tap out the 2 oil seals.

      SST
      09308-10010

  4. INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL


    1. A01WVBUE15
      *1 LH Side:
      *2 RH Side:
      *3 Differential
      *4 Seal

      Apply MP grease to 2 new oil seals.

    2. Using SST and a hammer, tap in the 2 oil seals.

      SST
      09550-00032
      09950-70010   ( 09951-07100 )

      Note

      Make sure the LH and RH oil seals are installed in the proper locations.

      Standard Oil Seal Depth
      Side Specified Condition
      LH -0.45 to 0.45 mm (-0.0177 to 0.0177 in.)
      RH 4.8 to 5.8 mm (0.189 to 0.228 in.)

  5. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

    Click here

  6. ADD DIFFERENTIAL OIL

    Click here